'Standard Quantum Limit' Smashed, Could Mean Better Fiber-Optic Comms
January 8, 2013
Communicating with light may soon get a lot easier, hints recent research* from the
National Institute of Standards and Technology (NIST) and the University of Maryland's Joint Quantum Institute (JQI),
where scientists have potentially found a way to overcome a longstanding barrier to cleaner signals.
The findings, which demonstrate for the first time an error rate far below the "standard quantum limit" for a wide range of light
levels, could increase the efficiency of fiber-optic systems by reducing both the power needed to send a signal and the number of
errors the receiver makes.
Light waves traveling through a fiber-optic cable often carry digital information encoded as differences in phase between one
wave and another. The crests of two waves that are "in phase" pass a point at the same time, while if the two waves are 180
degrees out of phase, one crest passes while the other's trough does. Receivers can be designed to detect more than just two
phase angles—0, 90, 180 and 270 degrees, for example—and the more phases they can detect, the more information can be packed
into a signal, increasing the rate of data transmission.
However, a constant problem is that phase states slightly overlap one another, meaning that there is a chance a state with
180-degree phase will be mistaken for a 0, 90 or 270-degree phase state. To minimize these errors, engineers must use more
optical signal power—which amps up the cost as well. A potential solution would be an improved receiver that does a better
job distinguishing among the different phase states. But designers have struggled for decades to get past a barrier they call
the standard quantum limit, which is the best performance an ideal conventional receiver could ever attain.
The research team, though, found a clever way to get past the standard quantum limit using off-the-shelf technology to construct
a receiver in an innovative way. Their solution is to make several measurements instead of a single one, and set them up so that
each measures a portion of the input light's phase state successively. The key to this "staged" approach is that the receiver makes
a partial measurement of the input phase state, and then uses the information obtained from this first partial measurement to
adapt itself before making the next one. None of the individual partial measurements is perfect, but the adaptive technology allows
a dramatically better final result.
"With a receiver implementing only a few adaptive measurements, we've managed to achieve error rates four times lower than the
standard quantum limit," says Francisco Elohim Becerra, a NIST/JQI postdoctoral fellow who is acknowledged by his co-authors as
having done the brunt of the work and originated the design.
While the innovation may not make its way into a fiber-optic system near you for some time, Becerra's coauthor Alan Migdall says
better phase measurement could lead to more efficient technologies that harness quantum effects, as well as improved data
* F.E. Becerra, J. Fan, G. Baumgartner, J. Goldhar, J.T. Kosloski and A. Migdall. Experimental demonstration of a receiver beating
the standard quantum limit for multiple nonorthogonal state discrimination.
Nature Photonics, Jan. 6, 2013, doi:10.1038/nphoton.2012.316.
More Stories in Fibers Optical Networks